Lets Build One!

[KRamone27]

Looking good! Man, that new spiral router bit really cuts clean.

Thanks Danny, after using the spiral bit I'm never using a straight flute bit again. Will use those for channels, cavities neck pockets etc.. I have a 2"cl bit that I use for jointing and it works really well.

[ludobag]

it is me or the axis is offset ?
looks good kevin
nice router bit

[mikethemod1992]

Looking good! Man, that new spiral router bit really cuts clean.

Thanks Danny, after using the spiral bit I'm never using a straight flute bit again. Will use those for channels, cavities neck pockets etc.. I have a 2"cl bit that I use for jointing and it works really well.

kevin, where did you get the bit'?

[KRamone27]

Looking good! Man, that new spiral router bit really cuts clean.

Thanks Danny, after using the spiral bit I'm never using a straight flute bit again. Will use those for channels, cavities neck pockets etc.. I have a 2"cl bit that I use for jointing and it works really well.

kevin, where did you get the bit'?

I bought it off a seller on amazon.com