Page 1 of 1
My string guide came loose.
Posted: Sat Oct 10, 2009 6:31 am
by billywrecker
What kind of glue should I use to fix it? I do need to order some hide glue to fix my upright bass, but I would rather use something that I could go out and find today.
Thanks
Re: My string guide came loose.
Posted: Sat Oct 10, 2009 8:08 am
by Bob Shade
Hello Billy, the right way to go is to gently sand the bottom of the string guide to get the old glue off, and do the same for the resting point on the neck. Then use Elmers or white glue to re-glue. This way if it ever needs to be removed you can still get it off. Not alot is needed, then re-string while the glue is wet. Let dry.
Bob Shade/ Hallmark Guitars
Re: My string guide came loose.
Posted: Sat Oct 10, 2009 8:24 am
by 101Volts
Bob Shade wrote:Hello Billy, the right way to go is to gently sand the bottom of the string guide to get the old glue off, and do the same for the resting point on the neck. Then use Elmers or white glue to re-glue. This way if it ever needs to be removed you can still get it off. Not alot is needed, then re-string while the glue is wet. Let dry.
Bob Shade/ Hallmark Guitars
+1, NEVER use epoxy.
Austin
Re: My string guide came loose.
Posted: Sat Oct 10, 2009 11:43 am
by billywrecker
Will do!Thanks alot!
Re: My string guide came loose.
Posted: Sat Oct 10, 2009 10:22 pm
by oipunkguy
I've used superglue before with success. the only downside is if you put on too much it can cause a mess. all you need is two very small drops if you decide to go this rout.
Re: My string guide came loose.
Posted: Mon Oct 12, 2009 6:05 am
by Haole Jim
Super glue is also very toxic and can attack some finishes and paint.
Re: My string guide came loose.
Posted: Fri Oct 16, 2009 7:23 am
by oipunkguy
different types of superglues is a regular tool for many luthiers, I agree with Bob's idea on gluing down the string guide, but at times I've have trouble making titebond stick to a surface that is metal to wood. which was the point to my added suggestion.
But also superglue can be used for finish repairs, whereas is not always the tool of choice in many cases, still has it's place on the right kind of repair.
Re: My string guide came loose.
Posted: Fri Oct 16, 2009 7:45 am
by dubtrub
I too use Cyanoacrylate form the hobby shop, though it's not Superglue brand. I use the (medium or thick) and it works great for metal string guides. I place a couple of small drops on the bottom of each side nearest the zero fret. I've never had a problem removing the guide at a later date. Simply use a small hammer with a wooden dowel and it pop right off.
Re: My string guide came loose.
Posted: Fri Oct 16, 2009 4:08 pm
by connie_mack
duct tape.
i swear by it.
ok, i'm kidding
Re: My string guide came loose.
Posted: Fri Oct 16, 2009 11:14 pm
by oipunkguy
duct tape is my most favorite tool in my shop
